Void INFINITE QX 6 Bedienerhandbuch PDF herunterladen (Seite 13)

Display What To Do

Press Exit to return to the Menu Selection. Press Enter to view

the version number. This selection cannot be changed.

This menu allows the Commander to be set for either Master or

Slave mode. Press Enter to change the Commanders mode.

Press “+” button to set the Commander to operate as a Master

Commander. Press Enter to accept the change.

Press the “-” button to set the Commander to operate as a

Slave Commander. Press Enter to accept the change.

Adding Additional Throttles

If you would like to have more than one operator on your layout, you may

add up to five additional Commanders (as Slaves), HandCommands, or any

other XpressNET compatible device to your Master Commander. When adding

additional Commanders, they must be configured as a Slave Commander.

Follow the steps below to configure your Commander as a Slave:

1. Connect the Commander to be configured as a Slave to a Generator and

plug the Generator in.

2. Press both the Forward and Reverse buttons at the same time to

access the Menu system.

3. Press the “+” or “-” buttons until the System Menu, SYS, is displayed

and follow the directions above right:

Display

What To Do

Press Enter to access the System Menu.

Use the “+” or ”-” button to select Y90. Press Enter to access

the configuration menu.

Use the ”-” button to change the display to “con”.

Connect the XpressNET cable from the Master Commander to

the Commander. Press Enter.

Your Commander is now configured as a Slave Commander. You may discon-

nect the Commander from the Generator, unless you intend to use the Slave

Commander for programming.

If you are adding more than one Slave Commander to you system you must

select a different XpressNET address for each Slave Commander. Follow the

steps below to select an now XpressNET address:

1. With the Slave Commander connected to either the XpressNET, or a

Generator, press both the Forward and Reverse buttons at the same

time to access the Menu system.

2. Press the "+" or "-" buttons to select the System Menu, SYS, and follow

the directions on the next page:

Y 9

EXPANDING YOUR SYSTEM

1 2 ... 8 9 10 11 12 13 14 15 16

Keine Kommentare

Void INFINITE QX 6 Bedienerhandbuch Seite 13